7" ID to 6" ID - Cobra Head Reducing - Rubber

7" ID to 6" ID - Cobra Head Reducing - RubberThis reducing cobra head elbow is 7" ID on the short end and 6" ID on the long end, and has a 1 8'NPT female pipe thread on one side. Cobra head elbows are used when clearance is extremely limited, such as when an air cleaner outlet is up against a firewall. There is no other way to make a really tight bend without losing air flow. How does the cobra head make such a tight bend without increasing turbulence? Because it flares out, creating more volume

This reducing insert adapts a 2" ID intake hose to a 1-1/2" OD tube

This 3-3/4" ID silicone coupler is 6 inches long

and then the 2-1/4" intake tube fits in the hole

You install it in the end of the 3" rubber elbow or hump hose

and D10298163

You install it in the end of the 2" rubber elbow or hump hose

25" OD tubes with a 45 degree bend

5 inch hump hose is used to connect two 3

and has the special black matte finish

and then the 2-3/4" intake tube fits in the hole

Recommended clamps are 94100-0750

This hose handles 350F continuous