Suspension Kit Swingarm 28-1112 DR200

Suspension Kit Swingarm 28-1112 DR200One kit does it all! All of the bearings, seals, shafts*, bushings, thrust bearings (if required) in one all inclusive kit to do the job correctly and completely. All bearing shafts manufactured with 52100 bearing steel that is hardened and centerless ground for a precision fit and extended wear life. All steel spacers are case hardened and plated for resistance to wear and corrosion. Needle thrust bearings have been replaced with Teflon bearings.

Height: 97mm

Built with a reserve cone for that old school racing sound and a stylish chrome plating finish these Dunstall replicas will look great on any custom build

Most of these have a 17 mm nut affixed onto the end that allows for easy removal

lubricants

while rear mounting kits allow them to be mounted to cases

High Quality Water Pump Rebuild Kit for CRF250R 2010-16

and the idler gears are manufactured from cold-headed steel

Extended length 28 3/8" (720 mm)

The pliers can be used vertically or horizontally

Inlet Size: 1-1/2"

Prefer larger controls

Using only the best flame-laminated dual-layer foam bonded with the highest quality glue