HR/VHR BIG BORE THROTTLE BODY KIT

HR/VHR BIG BORE THROTTLE BODY KIT10mm larger throttle plate OD over stock (70mm vs. 60mm) 36. 1% more area at the blade EPS Tuning CNC billet aluminum adapter plate Nisformance Plug & play adapter harness Very low merge angle between throttle body bore & intake manifold inlet for a smooth transition Improved throttle response and driveability characteristics Compliments larger diameter intake tubes for increased airflow and power Proven dyno and track gains

Upper plate o-rings

Steel reinforced upper gasket

Don't let your fresh rebuild start off with oil pressure problems

This problem can be as obvious as a blown out gasket but we've also found that gaskets that look fine from the outside also have issues due to the screw head fasteners used from the factory loosening up over time and causing the oil to seep out

1% more area at the blade

Replacement hardware that can be properly torqued down

Steel reinforced lower gasket

especially at the extremities of the plate

P0011 or P0021 codes then you need to check this

Compliments larger diameter intake tubes for increased airflow and power

have excessive VCT noise

We highly recommend to anyone that is removing the timing cover to at a minimum inspect these galleries and ideally replace these gaskets and the OEM fasteners that are hard to torque properly and uniformly across the plate